Fluke LinkRunner Especificaciones descargar pdf (Pagina 22)

Set Up the Tester

Reflector Configuration (LR-AT 2000 Model)

This screen is used to configure the LR-AT 2000 for remote

access to Fluke Networks EtherScope Network Assistant,

MetroScope Service Provider, and OptiView Analyzer’s

throughput performance tests.

Note

The LR-AT 2000 can reflect jumbo frame sizes up to

9600 bytes.

Select Tools > Reflector. The default or pre-configured

Reflector settings are displayed below

ffy32.bmp

Figure 12. Reflector Settings Screen

Select Configure.

ffy33.bmp

Figure 13. Reflector Default Configuration Screen

The LR-AT 2000 must be configured to:

MAC + Fluke - This filter setting allows the LR-AT 2000 to

only reflect packets when the destination MAC address

field matches the LR-AT 2000's own MAC address and Fluke

payload.

MAC + IP - This swap setting allows the LR-AT 2000 to swap

the source and destination MAC and IP addresses for

packets that are reflected back to the analyzer.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 38 39

Sin comentarios

Fluke LinkRunner Especificaciones Pagina 22