Fluke Ti10 Manual de usuario descargar pdf (Pagina 15)

Thermal Imagers

Adjusting the Thermal Image

Total Imager Range

SpanLevel

exj02.eps

Figure 1. Range and Span Settings

Setting the Level (Manual)

When put into manual ranging, the level setting adjusts the thermal span within

the total temperature range of the Imager. See Figure 1. To set the level:

1. After entering the manual range mode (See the “Setting the Range”

section above), press the softkey labeled Level.

2. Press the softkey labeled Up to move the temperature span to higher

temperatures or Down to move the span to lower temperatures.

3. Press the softkey labeled Done to set the Imager’s range level.

The scale along the right side of the display indicates the range.

Setting the Temperature Span (Manual)

When put into manual ranging, the span setting adjusts the palette over a

temperature range within the total range of the Imager. See Figure 1. To adjust

the temperature span:

1. After entering the manual range mode (See the “Setting the Range”

section above), press the softkey labeled Span.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Sin comentarios

Fluke Ti10 Manual de usuario Pagina 15